Name of each part
- STAY.
- an adsorption lever
- Rotation ball fixing bolts
- STAY ANGLE FIXING BOLT
- Double-Sided Tape Auxiliary Board
- a spinning ball

Select installation options
Select the mount type considering the structure of the vehicle and the location of the cradle.
- High angle.
Fold it short and hold it firmly without shaking.

- Low angle.
When it is installed at a low angle so as not to cover the front view when driving,

How to Install
- Carefully select the location to be fixed, considering the height and distance of the cradle. To secure the suction plate securely, attach the double-sided tape auxiliary plate first and then install the suction plate on it.


- When fixing the suction plate directly to the attachment surface or fixing the auxiliary plate with double-sided tape, be sure to remove any dirt or grease from the attachment surface with the enclosed alcohol pad.


- Remove the gel pad protection sheet (transparent).

- After setting the adsorption lever vertically, press the adsorption lever to adsorb it while strongly pressing it to prevent air leakage due to a gap between the adsorption plate and the attachment surface.

STAY adjust the angle.
- Release the stay angle fixing bolt and rotating ball fixing bolt to secure the desired stay angle and holder position and tighten it tightly so as not to shake.


- If the position of the cradle is too high or too low, you can adjust the insertion position by rotating the stay in the opposite direction as shown below.

precautions 

- Check the state of fixation and adsorption from time to time so that the adsorption power of the adsorption plate does not decrease and the product does not fall off.
- Adhesive gel pads attached to the suction plate may leave marks on the attachment surface if used for a long time. Traces can be removed with a neutral detergent and disappear naturally after a certain period of time.