KOREAN
ENGLISH
CHINESE
JAPANESEName of each part
- a spinning ball
- STAY
- an adsorption lever
- Support
- Absorption plate handle
- an adsorption plate
How to Install
- Remove any dirt or grease from the area to be fixed before attachment.
- Lift the suction lever up and remove the gel pad protective paper.
- Bring the suction plate to the fixed area and press it hard, press the adsorption lever to adsorb it.
After adsorption, check the adsorption status by lightly pulling the adsorption plate. When removing the suction plate, tilt the lever up and pull the suction plate handle up. 
- Adjust the stay by bending it to the desired height and angle.
How to fix the support
- Spread the support on both sides and insert it into the stay.
- Peel off the double-sided tape film on the support and attach it to the position to secure it so that the stay does not sag.
precautions 
- Please be careful if you fix the product in areas with rough surfaces such as carpets, artificial leather surfaces, and curved surfaces.
- Fix the product at room temperature (about 15-25°C) as it may reduce adhesion if it is fixed in the cold or hot weather.
- Check the fixed state of the suction plate from time to time so that the product does not fall due to vibration or direct sunlight while driving.
- Adhesive gel pads attached to the suction plate may leave marks on the attachment surface if used for a long time. Traces can be removed with a neutral detergent and disappear naturally after a certain period of time.
- Repeated transformations of the stay with excessive force can break the stay. Transform the stay with the right force and angle.