RITS 릿츠

Name of each part

a spinning ball
an adsorption plate lever
Length adjustment STAY
Angle adjustment knob
Double-Sided Tape Auxiliary Board

How to hold a phone

Select the mount type considering the structure of the vehicle and the location of the cradle.

Compact Stay
If you fold the STAYs short and hold them firmly without shaking

Long stay
Installation at a low angle to cover the front view or elongation of the stay

How to Install

Carefully select the location to be fixed, considering the height and distance of the cradle. To secure the suction plate securely, attach the double-sided tape auxiliary plate first and then install the suction plate on it.

Do not install suction plates on curved surfaces or material surfaces that are easily shaken or deformed by the weight of the cradle and phone (soft dashboards, fabrics, leather surfaces, carpet surfaces, etc.).

When fixing the suction plate directly to the attachment surface or fixing the auxiliary plate with double-sided tape, be sure to remove any dirt or grease from the attachment surface with the enclosed alcohol pad.

If the auxiliary plate is attached, do not hold the product for approximately 2 hours until it is sufficiently adhesive to the double-sided tape.

Gel pads that have lost adhesion due to long-term use are restored by washing them with water and drying them completely.

Remove the gel pad protection sheet (transparent).

After setting the adsorption lever vertically, press the adsorption lever to adsorb it while strongly pressing it to prevent air leakage due to a gap between the adsorption plate and the attachment surface.

precautions

Check the state of fixation and adsorption from time to time so that the adsorption power of the adsorption plate does not decrease and the product does not fall off.
Adhesive gel pads attached to the suction plate may leave marks on the attachment surface if used for a long time. Traces can be removed with a neutral detergent and disappear naturally after a certain period of time.